RC-offi.net

kenne kirjoitti: Scrap:
Onhan tuolla halkasija rajoituskin...vaikka vanne rajoitusta ei olisikaan.

Lainaus säännöistä:
- Kaikki tehdasvalmisteiset 1,9" renkaat ovat sallittuja. Itse valmistetut eivät saa olla yli 4,4" (112mm) korkeita.

Vaikka lukeekin itse valmistetut...mutta eikö se silti koske kaikkia??

Tiksissä kun kokeilin rataa.
1,9:sillä (Proline Swampper) todella vaikea kulkea tiiliradalla. 2,2 renkailla (Sedonna) helppo menä tiilen päälle. Vain esimerkkinä.

- Autoa saa liikuttaa vain sen renkaiden kautta maahan välittyvä voima. Kaikki tehdasvalmisteiset halkaisijaltaan
  1,9" tai pienemmille vanteille tarkoitetut   renkaat ovat sallittuja. Itse valmistetut eivät saa olla yli 4,4" (112mm)
  korkeita ja niidenkin pitää sopia halkaisijaltaan 1.9" tai pienemmille vanteille.

THuhtamäki kirjoitti: Josta tulikin mieleen että saisko nuilla RC4WD:n predator trackseilla ajaa 1.9" scalea??

Scrap kirjoitti: PS. Qaw, ei noita badlands kumeja voi oikein kieltää epäskalemaisina kun vastaavia saa 1:1 maastoautoihin. Esim. Fedima F-Cross

qaw kirjoitti: Kestipäs tässä kauan ;) Tiedän kyllä ko renkaan olemassaolon. On itseasiassa yksi vieläkin lähempänä oleva vanha rengas, mutta en nyt tähän hätään muista mikä se on.

Tire Ban List:

• Losi Claws (all sizes, and types)
• Hot Bodies Rovers (all sizes)
• Hot Bodies Sedonas
• HPI Rock Grabbers
• Panther Cougars
• Panther Leopards
• Pro-Line Chisels (all sizes)
• RC4WD Rocklin
• RC4WD X-Locks (all sizes)
• RC4WD Crazy Crawlers
• Imex Skulls and Bones
• Losi Bashers

Rcjunky3;4175 kirjoitti:1.9 and 2.2 Class

Chassis: The chassis or frame must be a ladder style and extend over the axles. Competition style RC rock crawling chassis are not allowed. This includes twin vertical plate designs (TVP), "stick" style, torsion and forced articulation. Tube style chassis are allowed. All tubers must have at least a hood, grille, and side panels. Tubers should try to adhere to the spirit of "scale" and look as realistic as possible.

Wheels & Tires:
1.9 class=Wheels are restricted to OEM 1.9” size and any modified tires may be no larger than 4.25” in height, 2.0 rims will be allowed but tires must still maintain the 1.9 parameters.
2.2 class=Wheels are restricted to OEM 2.2” size. all OEM tires are legal, any modified tires may be no larger then 5.5"

Body: any lexan or styrene body is legal

Steering: 4-wheel steering is illegal.

Drivetrain: A chassis mounted transmission and/or transfer case are allowed. Front or rear dig, cutting bakes, motor on axle (MOA) designs are illegal. Chassis with single or dual integrated motors are allowed, but the motors must always be powered (no electronic digs). A switchable transfer case is allowed, but only between 4x4 and 2x4 (rear wheel drive).

Wheelbase and width: The dimensions of the vehicle are limited only by the body, but it must fit within the body’s fender wells. discretion will be used with tubed vehicles

Comp-day modifications: The vehicle must be run as it was setup for tech inspection.

Battery: The Battery must be placed on or within the chassis.

Points:

Scale Class: All rigs in the Scale class will start off with 0 points and points will be deducted during the competitions. The object is complete the course without incurring points. Point deductions are listed below. Speed is rewarded.

Cleared Gate -2 points
Bonus Gate -10
Reverse + 1 point
Rollover + 5 points*
Gate + 10 points
Repair +10 points and 1 minute penalty
Touch + 5 points
Time: - 5 points (awarded if course completed in time allowance: An additional -5 points will be awarded to the fastest time)
DNF or Time expired + 40 points

Reverse: Using the throttle to reverse course. Non powered roll backs are allowed.

*Rollover: Points are assessed when a vehicle rolls over and does not right itself or can not be righted without touching. Winching is allowed without incurring a penalty. Once righted the vehicle must be driven back into position. All gates are still live while on a gated course.

Gate: Gate must be cleared in its intended direction. Winching through a gate is allowed. a gate may be taken with at least 1 front tire and 1 rear tire going through but gate penalty points will be accrued

Bonus Gate: will be optional and will need to be run before completing the course in the order it is placed. Example, if the bonus is set between gates 8 and 9 then the bonus will need to be attempted after clearing gate 8 and before going on to gate 9.

Touch: Any contact made to the vehicle by any person during a run with the exception of accessing your winch for use. If the touch is resulting in the vehicle being placed back on course the vehicle may not be placed any further forward than the most recent point of progress.

Winch: Winches may be used at any time along the course without penalty unless any part of the winch touches a gate. If that occurs a gate penalty will be assessed.

Time: A 6:00 minute time limit will be applied per run, this will be at the discretion of those running the event.

DNF: If a vehicle is unable to complete the course regardless of reason a DNF will be assessed. If a DNF is assessed then they will be scored with +40 points add to their current point total all progress points will be tallied and subtracted after your +40 is incurred

Courses:

The amount of courses will be pre-determined based on the amount of entries for each class. Recommendation is 3 courses per class. You can enter 1 vehicle in 2.2 class and 1 vehicle in the 1.9 class

Each course will be marked with a set of tennis balls and designated as such. Green is the start line, Yellow is a gate, Red is finish if any bonus is offered on a course it will be designated with a set of blue tennis balls.

2.2 will run their own separate courses

1.9 will run their own separate courses